I Just wrote that in your case the BIOS must be set to legacy mode. This is why your XP will not boot unless the BIOS is set to configure the disk controller in legacy mode. The person which installed your computer has done the last. Or you could set the BIOS to ancient legacy mode and just install XP without bothering with extra drivers.You could set the BIOS to AHCI (that is the normal SATA mode) and install XP with extra drivers.Since this was annoying to most people many computers got shipped with an option to use SATA devices in a legacy (IDE compatible) mode. Drivers which are not on the XP installation CD. This is not the same as the classic ATA (also called PATA). Your computer seems to have a SATA controller and a SATA disk. This could be done after installing the OS on a supported disk, or by pressing F6 and inserting the floppy with the drivers during installation of XP. a RAID card, many SCSI drivers, …) then you still need to load the drivers for that. If you used something to new or something unanticipated (e.g. Windows XP (and other operating systems) took advantage of this and added the most common drivers to their OS. In the past those drivers were loaded before you could start installing.Įventually the disk controllers and disks in most PC type computers standardised to something called IDE or ATA. In order to access a disk you need the right drivers. As Joseph already wrote, the problem is caused by the BIOS battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |